Adjusting The Gate Closure; Cleaning; Cleaning Debris From The Machine - Toro 33525 Operator's Manual

Adjusting the Gate Closure

1. If the gate arm is not fully closing, adjust the
control cable at the knob located on the cable
mount bracket or the nuts located on either side
of the hopper bracket.
2. Continue to adjust until the gate can be fully
closed; tighten all components.

Cleaning

Cleaning Debris from the
Machine
Service Interval: Before each use or daily
1. Shut off the engine, remove the key, wait for all
moving parts to stop, and engage the parking
brake.
2. Clean off any debris or buildup on the machine,
especially the impeller.
19