Installing The Wire Harness - Toro 33525 Operator's Manual

6

Installing the Wire Harness

Parts needed for this procedure:
1 Wire harness
10 Cable tie
Procedure
Important:
Be sure the machine is not running
and the key has been removed from the ignition
switch prior to proceeding with the harness
installation.
1. Disconnect the battery; refer to your Operator's
Manual.
2. Plug the hour meter and ON/OFF connectors on
the spreader harness into the switches on flow
control panel (Figure
1. Harness
2. Hour meter connector
3. Route the harness along the right side of the
machine, following the control cable. Place the
harness on top of the control cable and slide it
into the notch of the hopper bracket. Continue
to route the harness between the right hopper
8).
Figure 8
3. On/off switch
4. Motor connector
bracket and hopper tube. Connect the spreader
harness to the spreader motor as shown in
Figure 8. Insert the 3 harness tie clips into the
holes of the hopper mainframe to secure the
harness.
4. Remove the cap from the accessory wire on
the main harness and plug into the spreader
accessory harness as shown in
24 Inch Models Only: Remove the adaptor
plug from the main accessory harness.
1. Spreader harness
2. Accessory plug
3. Battery
4. Positive battery terminal
5. Spreader harness positive battery connection
6. Spreader harness negative battery connection
7. Negative battery terminal
g213636
5. Remove and retain the nut and screw from
the positive terminal on the battery. Install the
accessory harness positive cable (second to last
terminal ring—Figure
of the main harness to the front of the positive
battery terminal and secure with the nut and
screw. Repeat for negative battery cable.
6. Use the edge clip to secure the harness to the
right aerator panel.
10
Figure 9.
Figure 9
9) and the positive cable
g213882