7.
For 24-inch machines, use 1 cable tie to secure
the cable and harness to the spring or spring
mount.
Figure 10
1. Cable and harness
2. Cable tie
8.
Use the remaining cable ties to secure the
harness to the frame and/or control cable.
7
Installing the Cover
Parts needed for this procedure:
1
Cover
4
Washer
4
Locknut (1/4 inch)
4
Bolt (1/4 x 3/4 inch)
Procedure
1.
Attach the cover to the hopper in 2 places by
inserting a bolt (1/4 x 3/4 inch) and washer
through the cover tab grommet and hopper as
shown in
Figure
3. Spring mount
4. Spring
11.
g253434
1. Cover
2. Washer
2.
Secure with a locknut (1/4 inch).
3.
Plug the other 2 holes in the hopper with
remaining hardware.
11
Figure 11
3. Bolt (1/4 x 3/4 inch)
4. Locknut (1/4 inch)
g221638