Flasks And Round Flasks; Installing A 846 For Flasks And Round Flasks - Miele A 313 Operating Instructions Manual

Installing A 846
for flasks and
round flasks

Flasks and round flasks

Adjust the height of the frame.

- Flasks:
The height of the frame should be adjusted so that it comes to ap-
proximately halfway up the flasks.
- Round flasks:
The height of the frame should be adjusted so that it is approxim-
ately at the point of the largest diameter on the round flasks.
Remove one of the knurled nuts out of the module's injector rails.

Place the support for the A 846 on the threaded fitting and screw

the injector nozzle in .
Use a 17 mm spanner (WAF 17) to tighten the injector nozzle .

Place the rods on the frame above the injector nozzle.

Secure the rods on the right and left using the module's retaining

bars.
The distances between the rods and the retaining bars must be
roughly equal to the diameter of the load items.
en - Areas of application
39