Smart Probe Settings; Testo 115I/915I - Surface Increment - TESTO 915i Instruction Manual

1.800.544.2843
6 Using the App

6.4. Smart Probe settings

-> Sensors.
1. Press
3. Select the Smart Probe to display the details you would like to
see.
- A list with details about the Smart Probe appears in the
Information
4. You can activate the damping in the
If the readings fluctuate wildly, it is advisable to damp the readings.
The probe is connected to the SMART App.

1
Click on .

Main menu opens.
2
Click on Sensors.

The Sensors menu opens.
3 Click on the required sensor.

Information is displayed about the model, order number, serial number
and firmware version.
4 Settings
Click on the

The settings window opens.
5 Enable Activate damping
6 Click on Average of the measured

Window for Average of the measured values opens.
7 Enter a value between 2 and 20 seconds.

6.5. testo 115i/915i - Surface increment

Surface probes withdraw heat from the measured surface immediately
after the initial contact. This makes the measurement result lower than
14
www.calcert.com
15
10 20
5 25
0 30
tab.
Settings
tab.
using the slider.
values.
tab.
sales@calcert.com