Using The One-Touch Memory - BT Converse 2015 User Manual

Using the one-touch memory

To store a name and number in the
one-touch memory
This lets you store entries in the
one touch memory under the M1-M8
buttons.
Press and hold the
still holding the
The display will show PROGRAM MODE.
#
Release the button. The display will
show NO PIC.
Continue to press and release the
Hold button until the display shows
PROG PHONE MEM.
Press the Secrecy button. The display
shows PRESS M1 TO M8 TO CHANGE
MEM.
Press the M1-M8 button you want to
store the number under. The display
shows PHONE MEMORY: M1.
Press the Volume
see the stored number and name.
If no entry is stored, the display shows
MEMORY IS EMPTY.
Redial
Press the Redial button. The display
shows ENTER NEW NUMBER.
Enter the number you want.
If you make a mistake, press Redial to
delete digits.
If you need to insert a pause, press Pause
where required.
All manuals and user guides at all-guides.com
Converse 2015 ~ 4th Edition ~ 10th September '02 ~ 4517
#
button and whilst
#
button lift the handset.
+ –
or if you want to
Press the Secrecy button to confirm.
The display shows M1 NUMBER STORED
then ENTER NEW NAME.
Enter the name you want using the
letters on the keypad.
For example to enter the name ANNE:
Press once to enter A.
2
Press three times to enter N
6
Press three times to enter N
6
Press three times to enter E.
3
Each time you press the button the
letter alternates between capital and
lower case.
Press 1 to enter other characters e.g.
1
&, (, ).
If you make a mistake press the Redial
Redial
button to delete the last character.
+
Press Volume
cursor to the place you want.
Press the Secrecy button to confirm.
The display shows M1 NAME STORED.
Press the Hold or Redial button to
return to the Program Mode menu.
Replace the handset.
–
or to move the
11