AMG AMG2648R Instruction Manual

4 Channel Video RX Unit with 4 bi-directional data
AMG
PRIMARY OPTO SYNC DATA CHANNELS
TX RX RX RX
O O O O
CH1 CH3
O O
TX TX
O O
CH2 RX RX CH4
TX TX
O O
VIDEO PRESENT
CH1 CH2
O O
AUDIO CHANNELS
CH3 O O CH4
O O
CH1 TX RX
CH2 TX RX
O O
O O
CH3 TX RX
O O
CH4 TX RX
POWER POWER
O O
2648R
The AMG2648R is a four channel video receive unit. It also has the capacity to transmit and receive
four data and four audio signals. The data and audio interfaces are enabled by fitting data and audio
interface daughter boards. All the signals are transmitted and received over two multimode mode
optical fibres. The AMG2648R is designed to plug into an AMG2000 or an AMG2005 subrack, which
in turn fits into a 19" rack system.
The AMG2648R is designed to operate with AMG2647(R) four channel video transmit unit with four
channels of bi-directional audio and with four channels of bi-directional data.
Connections
Video Output Connections
No of Channels ....................................4
Connectors ......................................... 75 ohm BNC Socket.
Output Impedance ............................... 75 ohm terminated.
Output Level ........................................1 volt p-p nominal
Frequency Response .......................... 10Hz to 5.75MHz min.
Data and Audio Connections
No. of Data Channels .......................... 4
No. of Audio Channels ......................... 4
Connector ........................................... All on one 37 way D-Type female connector - shielded.
Connections......................................... See below for connection and configuration
AMG Systems Ltd. reserves the right to make changes to this document without
notice. The information herein is believed to be accurate. No responsibility is
assumed by AMG for its use.
and 4 bi-directional audio
AMG2648R
Instruction Manual
Page 1 of 6
CH 1
D
A
T
A
CH 2
OPTO
IN
A
N
D
CH 3
OPTO
OUT
A
U
D
CH 4
I
O
AMG2648R Instruction
Sheet D15534-01