Husqvarna TC 125 2022 Owner's Manual page 90

12 BRAKE SYSTEM
88
–
Position the vehicle vertically.
–
Remove screw cap
K01275-10
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does not
flow out of the brake fluid reservoir; extract some if neces-
sary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
ton.
M01328-10
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and the brake caliper bracket.
–
Check that spring plate
pad sliding plate
correctly.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
M00288-10
–
Insert the new brake linings, insert pin
3
pins .
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
the piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
M01329-10
point.
–
Correct brake fluid level to marking
Brake fluid DOT 4 / DOT 5.1 (
–
Mount and tighten screw cap
O-ring.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
K01274-10
1 2
with membrane and the O-ring.
3 4
, pull out pin , and remove the
5
in the brake caliper and brake
6
in the brake caliper bracket are seated
4
, and mount cotter
7
is mounted on
A
.
p. 127)
1
with membrane
2
and the