Husqvarna TC 125 2022 Owner's Manual page 120

19 TROUBLESHOOTING
Faults
Engine has too little power
Engine stalls or is popping into
the carburetor
Engine overheats
White smoke emission (steam
in exhaust gas)
Gear oil exits at the vent hose
Water in the gear oil
118
Possible cause
Diaphragm or reed valve hous-
ing damaged
Lack of fuel
Engine takes in bad air
The connector or ignition coil
is loose or oxidized
Too little coolant in cooling
system
Too little air stream
Radiator fins very dirty
Foam formation in cooling sys-
tem
Damaged cylinder head or
cylinder head gasket
Bent radiator hose
Damaged cylinder head or
cylinder head gasket
Too much gear oil added
Damaged radial shaft seal ring
or water pump
Action
–
Check the diaphragm and reed valve
housing.
–
Turn tap handle of the fuel tap to the
ON position.
–
Refuel. ( p. 32)
–
Check the intake flange and carbure-
tor for tightness.
–
Clean the connector and treat it with
contact spray.
–
Check the cooling system for leakage.
–
Check the coolant level. (
–
Switch off engine when stationary.
–
Clean the radiator fins.
–
Drain the coolant. ( p. 99)
–
Refill with coolant. (
–
Check the cylinder head and cylinder
head gasket.
–
Change the radiator hose.
–
Check the cylinder head and cylinder
head gasket.
–
Check the gear oil level. (
–
Check the radial shaft seal ring and
the water pump.
p. 98)
p. 99)
p. 110)