Husqvarna FC 250 2022 Owner's Manual page 73

SERVICE WORK ON THE CHASSIS 11
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers laterally to the
radiator.
–
Make sure that no cables or throttle cables are trapped or
damaged.
K01087-11
–
Attach the fuel tank breather hose to the fuel tank lid.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
K01086-11
–
Mount and tighten screws
Guideline
Screw, fuel tank
spoiler on radiator
K01085-11
–
Plug in connector
–
Remove the wash cap set and thoroughly clean the quick
release coupling using compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
–
Spray silicone spray onto a lint-free cleaning cloth and lightly
V01379-11 lubricate the O-ring of the quick-release coupling.
Silicone spray (
–
Join the quick-release coupling
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
–
Install the right side cover. (
–
Mount the seat. (
–
Install the air filter box cover. (
p. 77)
1
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
2
.
M6 6 Nm (4.4 lbf ft)
3
for the fuel pump.
p. 141)
4
of the fuel line.
p. 68)
p. 63)
p. 64)
71