Husqvarna FC 450 2022 Owner's Manual page 86

11 SERVICE WORK ON THE CHASSIS
84
–
Only loosen bleeder screw
der until filling is possible.
Info
Use water to immediately clean up any brake fluid
that has overflowed or spilled.
Avoid contact between brake fluid and painted
parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
(FX 450)
–
Fill bleeding syringe
fluid.
Syringe (50329050000)
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove the protection cap
and mount bleeding syringe
piece on bleeder screw
A01006-10
–
Only loosen bleeder screw
der until filling is possible.
Info
Use water to immediately clean up any brake fluid
that has overflowed or spilled.
Avoid contact between brake fluid and painted
parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
–
Now press the fluid into the system until it emerges from
6
hole of the master cylinder without bubbles.
–
Occasionally extract the fluid from the master cylinder reser-
voir to prevent overflowing.
–
Tighten the bleeder screw and remove the bleeding syringe
with the hose. Mount the protection cap.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
F00166-10
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
5
on the clutch slave cylin-
4
with the appropriate hydraulic
p. 143)
4
with an appropriate hose
5
.
5
on the clutch slave cylin-
4 mm (0.16 in)