Table of Contents
Advertisement
10.16
Handlebar position
10.17
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
Info
Turn clockwise to increase the damping; turn
counterclockwise to reduce damping when the shock
absorber rebounds.
–
Mount protection cap
The holes on the handlebar supports are placed at a distance
A
of
from the center.
Hole distance A
The handlebar can be mounted in 2 different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
H01188-10
Preparatory work
–
Remove the handlebar cushion.
Main work
–
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
Remove screws
–
Position rubber bushings
below.
–
Place handlebar supports in required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
H01189-10
TUNING THE CHASSIS 10
1
.
3.5 mm (0.138 in)
1
. Take off the handlebar clamp. Remove
2
. Take off handlebar supports
4
and push through nuts
2
.
3
.
5
from
49
Advertisement
Table of Contents
