Checking The Rubber Grip; Adjusting The Basic Position Of The Clutch Lever - Husqvarna FE 450 2022 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.41
12.42
86

Checking the rubber grip

401197-01
F03502-10
F03522-10

Adjusting the basic position of the clutch lever

F03503-10
Finishing work
–
Install the fuel tank. (
–
Install the right side cover. (
–
Mount the seat. ( p. 68)
–
Install the air filter box cover. (
–
Check the rubber grips on the handlebar for damage, wear,
and looseness.
Info
The rubber grips are vulcanized onto a sleeve on the
left and onto the handle tube of the throttle grip on the
right. The left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve
or the throttle tube.
» If a rubber grip is damaged, worn, or loose:
–
Change the rubber grip.
(All EU models)
–
1
Check that screw
Guideline
Screw, fixed M4
grip
A
Diamond must be positioned visibly as shown in
the figure.
(US)
–
1
Check that screw
Guideline
Screw, fixed M4
grip
A
Diamond must be positioned visibly as shown in
the figure.
–
Adjust the basic position of the clutch lever to your hand size
by turning adjusting screw
p. 78)
p. 72)
p. 69)
is firmly seated.
5 Nm (3.7 lbf ft)
®
Loctite
is firmly seated.
5 Nm (3.7 lbf ft)
®
Loctite
1
.
243™
243™