Ebyte E180-DTU User Manual page 23

Chengdu Ebyte Electronic Technology Co., Ltd
(4) After the node type is successfully written, modify other network parameters to establish the required ZigBee
network (you can also use the default values without modifying the parameters). Modify the channel, network PANID,
and tx power here. After modifying the parameters, you have to click "write network parameters ", the message box will
prompt" write parameters successful ".
(5) After the node type is modified, the device needs to be restarted to take effect. Click "Module restart", and the
message box prompts "Module restart successfully".
(6) After the module is restarted, it will enter the transmission mode by default. At this time, click "enter
configuration mode" again, and the message box will prompt "enter configuration state successfully, and read parameters
successfully". It can be seen that the parameters are the previously modified parameters, indicating that the network
parameters have been modified successfully.
Copyright ©2012–2017， 成都亿佰特电子科技有限公司
E180-DTU(ZG120-232) Usermanual
22