RedMax BCZ3050S Operator's Manual page 11

2. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
3. Move the choke lever to the choke position.
WARNING: The cutting attachment
starts to rotate immediately when you
start the engine with the choke.
4. Set the start/stop switch to the RUN position.
5. Hold the body of the product on the ground with your
left hand.
1561 - 003 - 05.10.2020
6. Hold the starter rope handle with your right hand and
the throttle trigger and throttle trigger lockout with
your left hand.
7. Slowly pull out the starter rope with your right hand
until you feel some resistance.
WARNING: Do not twist the starter rope
around your hand.
8. Pull the cord quickly and with force. Pull the starter
rope again and again until the engine starts.
CAUTION: Do not pull the starter rope to
full extension and do not let go of the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
9. Reset the choke when the engine fires.
10. Operate the throttle gradually when the engine
starts.
11. Make sure that the engine runs smoothly and let the
engine become warm for 1-2 minutes before
operation.
To stop the product
• Push the stop switch to stop the engine.
Blade thrust
• A blade thrust is a sudden movement of the product
to the side, forward or rearward. A blade thrust
occurs when the grass blade hits an object that
cannot be cut. In areas where it is not easy to see
the material being cut the risk of blade thrust
increases.
• When a blade thrust occurs, there is a risk that the
product or the operator moves out of position. A
blade that moves can hit bystanders and there is a
risk of injuries.
• If a blade is bent, has cracks, is broken or damaged,
discard the blade.
STOP
11