Mobile Home Installation; Rough-In Dimensions - Frigidaire FEQBB30DS0 Installation Instructions Manual

MOBILE HOME INSTALLATION

1. Dryer MUST be exhausted outside (outdoors, not beneath
the mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm) in
diameter with no obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area beneath the
mobile home is enclosed, the exhaust system MUST
terminate outside the enclosure with the termination
securely fastened to the mobile home structure.
3. When installing a gas dryer into a mobile home, a provision
must be made for outside make up air. This provision is to
be not less than twice the area of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 346764 is available from your dealer.
5. Refer to pages 2 and 3 for other important venting
requirements.
6. Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which is a Federal
Regulation Title 24 CFR-Part 32-80) or when such standard
is not applicable, with American National Standard for
Mobile Homes.
The dryer is designed under ANSI Z 21.5.1 or
ANSI/UL2158 - CAN/CSA C22.2 (latest editions) for HOME
USE only.
UNDER COUNTER & STACK MODELS

ROUGH-IN DIMENSIONS

(68.3 cm)
ELECTRIC CONNECTION
(6.5 cm)
13 1/2"
(34.4 cm)
3/8" (0.96 cm) Dia. GAS
(9.5 cm)
3/4"
2 1/4"
(1.9 cm)
(5.7 cm)
6
UNDER
COUNTER
34 5/8"
(87.9 cm)
PIPE
(2.54 cm)
REAR VIEW
47 1/2"
(120.7 cm)
4 3/8"
(11.1 cm)
OPTIONAL
VENT KNOCKOUT
(68.6 cm)
SIDE VIEW
35 1/4" 36"
(89.5 cm)
(89.5 cm)
3 3/4"
(9.5 cm)