Table of Contents
Advertisement
MOBILE
HOME INSTALLATION
1. Dryer MUST be exhausted outside (outdoors, not beneath
the mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm) in
diameter with no obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area beneath
the mobile home is enclosed, the exhaust system MUST
terminate
outside the enclosure with the termination
securely fastened to the mobile home structure.
3. When installing a gas dryer into a mobile home, a provision
must be made for outside make up air. This provision is to
be not less than twice the area of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 169840 is available from your dealer.
5. Refer to pages 2 and 3 for other important
venting
requirements.
6. Installation MUST conform to current Manufactured Home
Construction
& Safety Standard
(which is a Federal
Regulation Title 24 CFR-Part32-80) or when such standard
is not applicable, with American National Standard for
Mobile Homes. In Canada, the CSA Z240 is applicable.
The dr/er is designed underANSI Z 21.5.1 for
HOME USE only.
/
DON'T
L
Correct
Incorrect
Correct
Incorrect
DO
Correct
©
Incorrect
UNDER COUNTER
& STACK
MODELS
ROUGH-IN
DIMENSIONS
/
26 7/8"
(68.3 crn)
[_" ELECTRIC CONNECTION
2 9/16"_
(6.5 cm)
€-_ 13 1/2" -aN
(34.4
cm) /
0
u
L
3/8" (0.96 cm) DIA. T
t
UNDER
COUNTER
34 5/8"
(87.9 cm)
36"
(91.5 cm)
•
GAS PIPE
1"(2.54 cm)
REAR VIEW
DOOR OPEN 90 o
B
47 1/2"
(120.7 cm)
4 3/8"
(11.1
cm)
1
OPTIONAL
VENT KNOCKOUT-_,_,
27"
(68.6 cm)
<F--
''1'
v
3 3/4"
(9.5 cm)
SIDE VIEW
Advertisement
Table of Contents
