Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Installation
Leveling
WARNING: Use the leveling legs to level the
brewer only. Do not use them to adjust brewer
height. Do not extend them higher than necessary.
1
Position the brewer on the countertop. Level it left to
right and front to back by turning the bottom of the
legs.
Connect the Water Supply
2
Flush the water supply line prior to installation to
3
the back of the brewer. Leave the water supply valve
closed until the power is connected.
Connect the Brewer Wiring
Brewers With a Power Connector Mounted on the Back
4
Connect a C20 IEC power cord (not supplied)
compatible with the electrical outlet installed in the
Brewers With a Strain Relief Mounted on the Back
5
Remove the front panel.
6
Loosen the strain relief on the back of the brewer.
7
On dual voltage units being operated at 220-240 Volts
(nominal) disconnect the existing power cable from
the terminal block and remove. Disconnect and cap
the jumper wire between the "C" and "N" terminals on
the terminal block.
8
Feed the 220-240 Volt power cable into the brewer.
The brewer may be wired for connection directly to
a junction box or (if local ordinances permit) for use
with a power plug that connects to an electrical outlet
meeting the brewer SPECIFICATIONS.
9
Connect the wires on the power cable to the terminal
block inside the brewer.
10 Tighten the strain relief and replace the front panel.
DECANTER/DISPENSER BREWERS, INSTALLATION INSTRUCTIONS
Style
varies
Front
panel
Terminal
block
II8
or
081519C
Advertisement
Table of Contents
