GL-INET Velica User Manual page 115

Now Tor firmware is generally by imagebuilder and you will be able to install from
standard GLi software repositories using opkg. The source code is
on github now.
To modify and compile the Tor firmware by yourself, please refer to the following
imagebuilders.
imagebuilder for AR150, AR300M, MiFi, 6416
•
imagebuilder for AR300M Nand
•
imagebuilder for MT300N, MT300A
•
imagebuilder for MT300N-V2
•
Version 1.4:
Only support
GL-AR150
controlling whether you traffice should go through Tor or not.
button
Most of these instructions are for version 1.4.
Version 1.3:
Support ,
GL-AR150 GL.iNet6416
and Tor. If you conenct to OpenWrt you will have normal Internet. If you connect
to Tor, you will be connect to Tor network. This firmware has a built-in UI based
on Domino Pi which you can manage two SSIDs.
Version 1.0 with Luci:
Support and
GL-MT300A
MT300N with Luci. This firmware create two ssid: OpenWrt and Tor. If you
conenct to OpenWrt you will have normal Internet. If you connect to Tor, you will
be connect to Tor network. Connection from LAN port will always have Tor. Luci
is installed but there is no Domino Pi UI.
!!! Note
If you have questions about versions, please ask here or in the forum.
Download and Flashing the firmware to the device
All the firmwares is available at
name and then "tor" folder. Download the newest firmware.
You need to refer to
based on OpenWrt CC 1505
based on LEDE 17.01.4
, ,
GL-AR300M GL-MT300N
, . This firmware create two ssid: OpenWrt
GL-AR300
. This is the firmware created for MT300A and
GL-MT300N
https://dl.gl-inet.com/firmware/
Setup for instructions to flash the firmware to the router.
based on OpenWrt CC 1505
based on OpenWrt CC 1505
, , which has a
GL-MT300A switch
Find your device
Page 110 | 147