The stove do not requires chimney, anyway the room must be ventilated for a few minutes each hour of use.
The stove must be installed in compliance with the following safety conditions:
-Keep a minimum distance on the sides, in front of an above of 50 cm and 10 cm on the back by an average
of flammable materials;
-If the stove has installed on a floor that can be damaged, place in between a layer of heat insulating
materials;
This stove cannot be used in place tightly closed, or too small as campers, trailers,
passenger cars, boats...
5.
WORKING
A- Opening for the ignition
B- Glass Door
C- Regulation rod (C)
D- Essence holder container
The heater exclusively works with bioethanol. The burning is regulated by the rod (C).
WARNING: FILL ONLY WHEN THE STOVE IS OFF AND
COLD.
IF THE HEATER IS TURNED OFF BY IT SELF BECAUSE
THE BIOETHANOL IS FINISHED, ALWAYS CLOSE THE
TANK WITH THE REGULATION ROD ( C ) AND MAKE
SURE THE FLAME IS COMPLETELY OFF BEFORE TO
REFILL THE STOVE.
Pag. 20 di 28
D
B
A
C
The bioethanol feeding take place as follows:
F/G
E- Fan air intake
F- Socket for power cable
G- on/off switch
WARNING: THE FIBER PLACED INSIDE THE BURNER
WILL ABSORB THE BIOETHANOL ARMED, TO
GUARANTEE MORE SAFETY FOR THE STOVE.
PROCEED TO FILL THE BIOETHANOL IN A GRADUAL
WAY TO ENSURE WITHOUT OVERFLOOD THE
REGULAR ABSORBING, AND IN CASE REMOVE THE
OVERFLOWING IMMEDIATELY.
E
Need help?
Do you have a question about the Ruby Elegance and is the answer not in the manual?
Questions and answers