Changing The Handle And Switch - Bernard Q20 Series Owner's Manual

7-5 Changing the Handle and Switch

A. B Series Regular and Small Curved Handle
1. Remove screws and post fasteners from handles.
2. Separate handle halves and remove trigger.
3. Remove switch lead connectors with needle nose pliers.
4. To replace trigger, connect switch lead connectors onto
terminals of new switch. Position handle half and trigger on
cable so trigger leads are not pinched and movement of the
trigger is not impaired.
5. Position the remaining handle half in place.
6. Reinstall post fasteners and screws. Torque to 10 in-lbs (1.1
Nm).
B. O Series Regular and Small Curved Handle
1. Loosen screws, but do not fully remove.
2. Pry open bottom side of handle halves with a flat blade
screwdriver. Trigger should be able to be removed.
3. To replace trigger, install into handle halves with pivot posts
inserted into handle cavities so movement is not impaired.
4. Tighten screws. Torque to 10 in-lbs (1.1 Nm).
20 OM-BTB-2.4
Figure 7-L
Figure 7-M