Microlife BP3GU1-8X Instruction Manual page 23

5.5. Memory: reviewing readings
At the end of a measurement, this monitor automatically
stores each result with date and time. This unit stores 99
memories for each of 2 users.
Viewing the stored values
With the unit unlocked, press the memory button, "M".
The display first shows an average of all measurements
stored in the unit. The averaged measurement is indicat-
ed by the "A" in the upper right of the display. Please
note: Measurements for each user are averaged and
stored separately. Be certain that you are viewing the
measurements for the correct user.
Pressing the plus button displays the previous value. To
view a particular stored memory, use the plus and minus
buttons to scroll to that stored reading.
Memory full
When the memory has stored 99 results, a new, measured
value is stored by overwriting the oldest value.
Clear all values
To permanently remove all stored values: From a starting
screen (only the time and user icon showing) hold down
the "M" button until "CL" appears and then release the
button. If you do not want to clear the values, press the
START/STOP button. To permanently clear the memory,
press the "M" button while "CL" is flashing.
Individual values cannot be cleared
5.6. Stopping a measurement
If it is necessary to interrupt a blood pressure measure-
ment for any reason (e.g., the patient feels unwell), the
START/STOP button can be pressed at any time. The
device then immediately lowers the cuff pressure
automatically and enters sleep mode.
21