Cleaning And Maintenance; Troubleshooting - BOMANN SBS 7323.1 IX Instruction Manual

Tips for Energy saving
 Disconnect the appliance from the power supply,
if it isn't in use.
 Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
 Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
 Place all shelves, racks or drawers (depending on
the model) in their original position.
 Adjust the temperature not colder than necessary.
 Allow warm food to cool before placing it in the
appliance.
 Open the unit door only as necessary.
 Defrost the unit regularly (model dependent).
 The seal of the appliance door must be complete-
ly intact, so that the door closes properly.

Cleaning and Maintenance

WARNING:
 Always disconnect the appliance from the power
supply before cleaning and user maintenance.
 Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
 The unit must be dry before restarting operation.
CAUTION:
 Do not use a wire brush or other sharp, abrasive
items.
 Do not use any acidic or abrasive detergents.
 Do not damage the refrigerant circuit.
Cleaning the appliance including interior
 Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
 Remove the appliance content and storage it at a
cool location.
 After everything was thoroughly dried, you can
restart the operation.
Defrosting
The appliance keeps free from ice inside because of
the NoFrost System. A defrosting procedure isn´t
necessary.
Changing the bulb
CAUTION:
Do NOT remove the cover of the interior light.
The LED light may be replaced / repaired in case of
failure / defect only by an authorized specialist.

Troubleshooting

Before you contact an authorized specialist
Problem Cause / Action
Unit is not ∙ Check the power supply / tempera-
working ture setting / ambient temperature.
properly or ∙ Unblock the ventilation openings,
at all install the unit freely.
Loading is too ∙ Check the temperature setting /
warm ambient temperature. ∙ Open the
door only as long as necessary.
Loud noise ∙ Check the appliance position.
during opera- ∙ See the section "Operating noise".
tion
Water on the ∙ Check the temperature setting.
unit bottom
Light does not ∙ Check the power supply.
work ∙ See "Changing the bulb".
24