Advertisement
Assembly and Installation (Continued)
□
Place the wire connector (E) on opposite sides of the low
voltage cable (G) where the fixture will be located.
□
Align and fit the main low voltage cable (G) vertically to the
slot of wire connector (E) as shown.
□
Press the wire connector (E) together until fully seated and
locked around the cable (G). Pre-set prongs will pierce the
cable insulation and establish contact. Turn on the power unit.
If the light fixture does not turn on, repeat previous steps.
□
Once the clip-on connector (E) is in place, wrap it with
electrical tape for additional protection.
□
After all fixtures are installed, turn on the transformer.
CAUTION: BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
E
3
Installing the control box
□
This control box (H) is weatherproof and suitable for outdoor use.
□
Do not install behind shrubs. It will affect the dusk-to-dawn
photocell.
□
Photocell will not operate properly if installed too close to a
nighttime light source.
□
MOUNT AT LEAST 12 in. (30 cm) ABOVE GROUND.
□
Mount the controller with a screw (not included) on a wall within
1 ft. (30.5 cm) of the electrical outlet where the transformer will be
connected.
□
The control box (H) goes between the transformer (F) and the
lights. Plug them together and secure them with screw caps.
4
Connecting the cable to the transformer
Note: Prior to installing and powering the transformer, a safety approved GFCI receptacle
(fig. 1) and GFCI watertight protective cover (fig. 2)– (not supplied) must be installed by
a qualified electrician. GFCI receptacle and cover must be mounted a minimum of 12 in.
(0.3 m) above ground level. The transformer must be mounted at least 1 ft. (0.3 m) above
ground level.
□
Connect the wire to the transformer (F).
□
Screw the watertight connector by turning clockwise.
□
Plug the transformer (F) into the GFCI receptacle.
F
H
fig. 1
fig. 2
Advertisement
