Setup; Checking The Engine-Oil Level; Checking The Skids And Scraper; Checking The Operation Of The Traction Drive - Toro Power TRX Commercial 1428 OHXE Operator's Manual

Setup

1
Checking the Engine-Oil
Level
No Parts Required
Procedure
Note:
Your machine comes with oil in the engine
crankcase. Before starting the engine, check the oil
level and add oil if necessary.
Refer to Checking the Engine-Oil Level (page
2
Checking the Skids and
Scraper
No Parts Required
Procedure
Refer to Checking and Adjusting the Auger Skids and
Scraper (page 16).
3
Checking the Operation of
the Traction Drive
No Parts Required
Procedure
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
16).
Carefully check the traction drive and adjust it
properly, if necessary.
1. Start the engine; refer to
(page
2. Pull the speed selector slightly out of the neutral
position; refer to
(page
3. Squeeze the left (traction) lever to the handgrip
(Figure
The machine should move rearward. If the
machine does not move or moves forward,
complete the following:
A. Release the traction lever and shut off the
engine.
B. Loosen the 2 nuts on the speed cable
resting on the speed-selector-lever bracket,
located under the control panel
5
Starting the Engine
9).
Operating the Speed Selector
12).
4).
Figure 4
g322974
(Figure 5).