Checking And Adjusting The Track Skids; Checking And Adjusting The Track Tension - Toro Power TRX Commercial 1428 OHXE Operator's Manual

Checking and Adjusting the
Track Skids
Service Interval: Yearly
1. Refer to Preparing for Maintenance (page
2. Loosen the skid bolts (A of
3. Lower the skid so that it is tangent with the front
and rear track rollers (B of
4. Tighten the skid bolts (C of
Figure 24
15).
Figure 24).
Figure 24).
Figure 24).
g325810
17
Checking and Adjusting the
Track Tension
Service Interval: Monthly
1. Refer to Preparing for Maintenance (page
2. Apply 44 N (10 lbf) between the middle and rear
roller (Figure 25).
Figure 25
3. Ensure that the deflection of the track is
approximately 9.5 mm (3/8 inch).
4. If the track deflection is not approximately 9.5
mm (3/8) inch or if the tracks are jumping, adjust
the track tension as follows:
A. Slightly loosen the nuts on the rear roller
yoke (Figure
Figure 26
1. Rear-roller-yoke nuts
B. Adjust the hex head bolt as needed
27).
Note:
Turn the bolt clockwise if the track
has more than 9.5 mm (3/8 inch) deflection.
Turn the bolt counterclockwise if the track
has less than 9.5 mm (3/8 inch) deflection.
26).
15).
g325787
g325788
(Figure