Cabinet Location, Leveling Legs & Castors - True TSCI Series Installation Manual

Installation (cont.)
Cabinet Location
1. Ensure that the drain hose or hoses are positioned in the pan.
2. Free the plug and cord from inside the lower rear of the cooler
(DO NOT plug in).
3. Place the unit close enough to the electrical supply so that the
extension cords are never used.
Installing Leveling Legs
Leveling legs are provided to assist with leveling the cabinet.
With access to the bottom of the cabinet, thread the leveling legs
into the holes used to secure the cabinet to the skid. See figs. 1
and 2.
Fig. 1. Turn the leveling legs clockwise to lower the unit.
Fig. 2. Turn the leveling legs counterclockwise to raise the unit.
Fig. 3. Locate the threaded hole in the
rail.
Fig. 5. Turn the bottom stem to level the
cabinet.
Page 6 of 32
S C I E N T I F I C S E R I E S
Fig.4. Screw in the leveling legs.
Lower Rail
Assembly
Rail End
Snug Fit
Here
Leg
Bottom Stem
Installing 6" Leveling Legs or Castors
Adjustable legs will provide 6" (152 mm) of clearance under the
cabinet. Castors provide cabinet mobility.
NOTE: If the cabinet has a center leveling screw, castor, or leg,
make sure it is adjusted properly so it makes full contact with
the floor after the cabinet has been leveled.
Required Tools
Adjustable Wrench
6" Leveling Legs
1. Access the bottom of the cabinet and thread the leveling legs
into the rail. See figs. 3 and 4.
2. Verify that the cabinet is level.
3. If the cabinet is not level, gently lift and support the low end
of the cabinet. With an adjustable wrench, screw the bottom
stem of the leveling leg in or out to level and support the
cabinet. See fig. 5.
Castors
1. Loosen the castor bolt enough to slide the provided castor
shims between the castor bearing and the bottom rail of
the cabinet. See fig. 6.
2. Install the desired number of shims. If more than one shim is
used, turn the slots at a 90˚ angle to each other, so the slots do
not align. See figs. 7 and 8.
3. Tighten and secure the shims and castors with the optional
castor wrench. Lower the cabinet and verify that it is level. If
the cabinet is not level, repeat the process until the cabinet is
level and supported.
Fig. 6. Loosen castor bolt.
Fig. 8. Position multiple shims at
90˚ angles.
10/12/2020
truemfg.com
Fig. 7. Install shim(s).
Castor Stem
Lower Rail Assembly
Rail End
Snug Fit Here
Bearing Race
Leveling Shim
Castor
TEC_TM_098 REV. A