After Operation; After Operation Safety; Using The Fuel-Shutoff Valve; Pushing The Machine By Hand - Toro Z Master Professional 7000 Series Operator's Manual

After Operation

After Operation Safety

After Operation Safety
General Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel and remove the key before storing
or transporting the machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Using the Fuel-Shutoff
Valve
The fuel-shutoff valve is located under the seat. Move
the seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance,
and storage.
Ensure that the fuel-shutoff valve is open when
starting the engine.
Figure 36
1. O position
N
g008948
2. O position
FF
Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Rotate the bypass valves counterclockwise 1
turn to push (Figure
Note:
This allows hydraulic fluid to bypass the
pump enabling the wheels to turn.
Important:
Do not rotate bypass valves
more than 1 turn. This prevents valves from
coming out of the body and causing fluid to
run out.
4. Disengage the parking brake before pushing.
31
37).