Frigidaire FAH12EN2T Installation Instructions Manual page 3

Wall Sleeve Brands:
Rear Louvers
60
Top View
3
6
2
#1 Emerson
1. Redirect the louvers at the back of the wall sleeve as shown in the
illustration. The use of pliers is recommended.
10-1/4"
60
2. Attach (1) 1
10 1 ⁄
" ‹
4 3. Attach the (2) 1
louvered pane. Install the seals as shown in the illustration.
4. Cut the 1
2
inside of the louvered panel as shown in the illustration. Attach the
(2) 4
3
to the inside of the sleeve with the Tappered End facing the opening.
These (2) blocks should be locaed approximately in the center of the
side walls. To attach the blocks remove the backing paper from the
blocks. Do not touch adhesive on the blocks. Press the blocks firmly
4
in place.
5. Install the new unit into the wall sleeve.
6. Attach the ground wire to the unit as shown.
7. Install the 1"x 1
and the unit. A flat bladed screwdriver or putty knife is recommended.
7
7
8. Assemble and install the Trim Frame. (see Trim Frame)
1 ⁄ "x 3/8"x 26 1 ⁄ "long seal as shown in the illustration.
2 2
1 ⁄ "x 3/8"x 14"long seals, to the inside of the
2
⁄ "x 3/8"x 26 ⁄ "long seal to 14"long, and attach it to the
1 1
2 2
1 ⁄ "x 3 1 ⁄ "x 1 1 ⁄ "Centering/Support Blocks, one on each side wall,
2 2 2
1 ⁄ "x 84"long stuffer seal between the wall sleeve
2
15"Deep