Frigidaire FAH12EN2T Installation Instructions Manual page 12

Wall Sleeve Brands:
Rear Louvers
60
9-1/2"
Top View
2
6 1 ⁄
"‹
2
3
3
5
#6 Whirlpool
1. Redirect the louvers at the back of the wall sleeve as shown in the
illustration. The use of pliers is recommended.
10"
60
2. Cut (2) Tapered Spacer Blocks and install as shown in the
10"‹
illustration. To attach the blocks remove the backing paper from the
blocks. Do not touch adhesive on the blocks. Press the blocks firmly
in place.
3. Cut and attach the (1) 1
6 1 ⁄
"‹
2
Attach the (2) 1
4. Attach 1"x 3/4"x 14"long seal to the louvered panel as shown in the
illustration.
4
5. Install the new unit into the wall sleeve.
Attach the ground wire to the unit as shown.
6. Install the 1"x 1
A flat bladed screwdriver or putty knife is recommended.
6
3/4"
Cut Here
1 ⁄ "x 3/8"x 26
2
⁄ "x 3/8"x 14"long seals as shown.
1
2
1 ⁄ "x 84"long stuffer seal between the wall sleeve and the unit.
2
6
8. Assemble and install the Trim Frame.
(see Trim Frame)
17"
1"
Tapered Spacer Block
13"
Protection Paper Backing
1 ⁄ "long seal to 25 1 ⁄
2 2
17 1 ⁄
"Deep
8
"long.
7