Frigidaire FAH12EN2T Installation Instructions Manual page 11

Wall Sleeve Brands:
Rear Louvers
60
9-1/2"
Top View
2
6 1 ⁄
"‹
2
3
3
5
6
#5 Sears or Carrier (51S Series)
1. Redirect the louvers at the back of the wall sleeve as shown in the
illustration. The use of pliers is recommended.
10"
60
2. Attach (2) Tapered Spacer Blocks to the inside of the wall sleeve as
10"‹
shown in the illustration.
DO NOT CUT THESE BLOCKS.
6 1 ⁄
"‹
2
3. Attach the (1) 1
(2) 1
4. Attach the 1'x 3/4"x 14"long seal to inside of the louvered panel as
shown in the illustration. Install the new unit into the wall sleeve.
3
4
5. Attach the ground wire to the unit as shown.
6. Install the 1"x 1 1
flat bladed screwdriver or putty knife is recommended.
6
1 ⁄ "x 3/8"x 26
2
1 ⁄ "x 3/8"x 14'long seals as shown in the illustration.
2
⁄ "x 84"long stuffer seal between the wall sleeve and the unit. A
2
6
7. Assemble and install the Trim Frame.
(see Trim Frame)
17"
3/4" Tapered Spacer Block
13"
1 ⁄ "long seals and the
2
18 5 ⁄
"Deep
8
1"
Protection Paper Backing