Goldacres Pro-Reel 200L Operator's & Parts Manual page 24

3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
THROTTLE LEVER
1. Operate the starter:
RECOIL STARTER
Some engine applications use a remote-mounted throttle control
MIN.
• Pull the starter grip lightly until you feel
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
resistance, then pull briskly in the direction
of the arrow as shown below. Return the MIN.
4. Turn the engine switch to the ON position.
starter grip gently.
EXCEPT ELECTRIC
Some engine applications use a remote-mounted throttle control
STARTER TYPES
NOTE: Do not allow the starter grip to snap
rather than the engine-mounted throttle lever shown here. Refer
back against the engine. Return it gently to
to the instructions provided by the equipment manufacturer.
ELECTRIC STARTER TYPES
ENGINE SWITCH
prevent damage to the starter.
4. Turn the engine switch to the ON position.
EXCEPT ELECTRIC
ENGINE SWITCH
STARTER TYPES
ELECTRIC STARTER
• Turn the key to the START position, and
ON
ENGINE SWITCH
hold it there until the engine starts.
• When it starts, release the key, allowing it to
ON
return to the ON position.
ON
NOTE: Using the starter for longer than 5
ON
seconds at a time will overheat the motor and
can damage it. This type of overheating is not
covered under warranty. If the engine fails to
start within 5 seconds, release the key, and
wait at least 10 seconds before trying the
starter again.
2. If the choke lever was moved to the
CLOSED position to start the engine,
gradually move it to the OPEN position as
the engine warms up.
37Z4V6100.fm 6 ページ ２０１８年１０月４日 木曜日 午後１時５４分
STOPPING THE ENGINE
To stop the engine in an emergency, simply turn the engine switch
to the OFF position. Under normal conditions, use the following
procedure. Refer to the instructions provided by the equipment
manufacturer.
1. Move the throttle lever to the MIN. position.
Setting Engine Speed
Some engine applications use a remote-mounted throttle control
Move the throttle lever to somewhere between
rather than the engine-mounted throttle lever shown here.
the MAX. and MIN. position to set desired
engine speed.
IMPORTANT: The reduction gearbox operates
at a 6:1 ratio from the engine to the pump.
The spray pump speed should not exceed
540 RPM. Therefore the engine should not be
allowed to run over 3250 RPM.
2. Turn the engine switch to the OFF position.
EXCEPT ELECTRIC
STARTER TYPES
ENGINE SWITCH
MAX.
MIN.
MAX.
MIN.
1/3 POSITION
MAX.
ELECTRIC STARTER TYPES
ON
ELECTRIC STARTER TYPES
ON
ON
ON
ENGINE SWITCH
ENGINE SWITCH
ENGINE SWITCH
6. If the choke lever was moved to the CLOSED position to start
THROTTLE LEVER
ENGLISH
MIN.
ELECTRIC STARTER TYPES
OFF
OFF
briskly in the direction of the arrow as shown below. Return the
RECOIL STARTER:
starter grip gently.
5. Operate the starter.
Pull the starter grip lightly until you feel resistance, then pull
briskly in the direction of the arrow as shown below. Return the
RECOIL STARTER:
starter grip gently.
MIN.
Pull the starter grip lightly until you feel resistance, then pull
1/3 POSITION
briskly in the direction of the arrow as shown below. Return the
starter grip gently.
MIN.
1/3 POSITION
Direction to pull
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
ON
ELECTRIC STARTER (applicable types):
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
Turn the key to the START position,
and hold it there until the engine
ELECTRIC STARTER (applicable types):
Do not allow the starter grip to snap back against the engine.
starts.
Return it gently to prevent damage to the starter.
Turn the key to the START position,
ON
If the engine fails to start within 5
and hold it there until the engine
ELECTRIC STARTER (applicable types):
seconds, release the key, and wait at
starts.
least 10 seconds before operating the
Turn the key to the START position,
ON
starter again.
If the engine fails to start within 5
and hold it there until the engine
seconds, release the key, and wait at
starts.
least 10 seconds before operating the
Using the electric starter for more
starter again.
If the engine fails to start within 5
than 5 seconds at a time will overheat
seconds, release the key, and wait at
the starter motor and can damage it.
least 10 seconds before operating the
This type of overheating is not
Using the electric starter for more
ON
starter again.
covered under warranty.
than 5 seconds at a time will overheat
the starter motor and can damage it.
When the engine starts, release the
This type of overheating is not
Using the electric starter for more
key, allowing it to return to the ON
covered under warranty.
than 5 seconds at a time will overheat
position.
the starter motor and can damage it.
When the engine starts, release the
This type of overheating is not
6. If the choke lever was moved to the CLOSED position to start
key, allowing it to return to the ON
covered under warranty.
the engine, gradually move it to the OPEN position as the
position.
engine warms up.
When the engine starts, release the
key, allowing it to return to the ON
the engine, gradually move it to the OPEN position as the
position.
engine warms up.
6. If the choke lever was moved to the CLOSED position to start
the engine, gradually move it to the OPEN position as the
engine warms up.
OPEN
SETTING ENGINE SPEED
Position the throttle lever for the desired engine speed.
CLOSED
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipment manufacturer.
For engine speed recommendations, refer to the instructions
provided with the equipment powered by this engine.
ENGLISH
MIN.
ENGLISH
MAX.
OFF
24
STARTER GRIP
STARTER GRIP
Direction to pull
Direction to pull
START
START
ENGINE SWITCH
(applicable types)
CHOKE LEVER
OPEN
CLOSED
OPEN
OPEN
CLOSED
THROTTLE LEVER
MIN.
STARTER GRIP
START
START
START
START
ENGINE SWITCH
(applicable types)
ENGINE SWITCH
(applicable types)
CHOKE LEVER
CHOKE LEVER
OPEN
OPEN
5
5
MAX. MIN.
5
MAX. 3250 RPM