Goldacres Pro-Reel 200L Operator's & Parts Manual page 23

you find, or have your servicing dealer correct it, before you
operate the engine.
Failure to properly maintain this engine, or failing to
correct a problem before operation, could result in a
significant malfunction.
Failure to properly maintain this engine, or failing to
Circuit Protector
Some malfunctions can seriously hurt or kill you.
correct a problem before operation, could result in a
OIL DRAIN PLUG
significant malfunction.
If the motor has been optioned with electric
Always perform a pre-operation inspection before
start, then it will also have a circuit protector each operation and correct any problems.
Some malfunctions can seriously hurt or kill you.
AIR CLEANER
fitted which protects the battery charging
Before beginning your pre-operation checks, be sure the engine is
MUFFLER Always perform a pre-operation inspection before
circuit. A short circuit, or a battery connected
level and the engine switch is in the OFF position.
each operation and correct any problems.
with reverse polarity, will trip the circuit
Always check the following items before you start the engine:
Before beginning your pre-operation checks, be sure the engine is
SPARK PLUG protector.
level and the engine switch is in the OFF position.
Check the General Condition of the Engine
The green indicator inside the circuit protector
Always check the following items before you start the engine:
will pop out to show that the circuit protector
1. Look around and underneath the engine for signs of oil or
gasoline leaks.
has switched off. If this occurs, determine the
Check the General Condition of the Engine
cause of the problem, and correct it before
2. Remove any excessive dirt or debris, especially around the
1. Look around and underneath the engine for signs of oil or
muffler and recoil starter.
resetting the circuit protector.
gasoline leaks.
3. Look for signs of damage.
ENGINE CONTROL TYPES
2. Remove any excessive dirt or debris, especially around the
Push the circuit protector button to reset.
muffler and recoil starter.
FUEL VALVE LEVER
4. Check that all shields and covers are in place, and all nuts,
Starting Engine
bolts, and screws are tightened.
3. Look for signs of damage.
CHOKE LEVER
1. Move the fuel valve lever to the ON
Check the Engine
4. Check that all shields and covers are in place, and all nuts,
position.
bolts, and screws are tightened.
1. Check the fuel level (see page 8). Starting with a full tank will
help to eliminate or reduce operating interruptions for refueling.
Check the Engine
2. Check the engine oil level (see page 8). Running the engine with
1. Check the fuel level (see page 8). Starting with a full tank will
a low oil level can cause engine damage.
help to eliminate or reduce operating interruptions for refueling.
THROTTLE LEVER
The Oil Alert system (applicable types) will automatically stop
2. Check the engine oil level (see page 8). Running the engine with
2. If the engine is cold, move the choke
the engine before the oil level falls below safe limits. However,
a low oil level can cause engine damage.
to avoid the inconvenience of an unexpected shutdown, always
lever to the CLOSED position.
ENGINE
check the engine oil level before startup.
The Oil Alert system (applicable types) will automatically stop SWITCH
the engine before the oil level falls below safe limits. However,
3. Check the reduction case oil level on applicable types (see page
to avoid the inconvenience of an unexpected shutdown, always
If restarting a warm engine, leave the choke 9). Oil is essential to reduction case operation and long life.
check the engine oil level before startup.
CIRCUIT
CHOKE LEVER
PROTECTOR
lever in the OPEN position.
(air cleaner low profile type)
4. Check the air filter element (see page 10). A dirty air filter
3. Check the reduction case oil level on applicable types (see page
element will restrict air flow to the carburetor, reducing engine
9). Oil is essential to reduction case operation and long life.
performance.
3. Move the throttle lever approximately 1/3
4. Check the air filter element (see page 10). A dirty air filter
5. Check the equipment powered by this engine.
element will restrict air flow to the carburetor, reducing engine
of the way from the MIN. position.
performance.
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should
5. Check the equipment powered by this engine.
be followed before engine startup.
Review the instructions provided with the equipment powered
by this engine for any precautions and procedures that should
be followed before engine startup.
4. Turn the engine switch to the ON
position.
4
4
ELECTRIC STARTER
(applicable type)
OIL FILLER CAP/DIPSTICK
RECOIL STARTER
STARTER GRIP
EXCEPT ELECTRIC STARTER
TYPES
ENGINE SWITCH
ELECTRIC STARTER TYPES
ENGLISH
monoxide gas that can collect rapidly in an enclosed area and
Carbon Monoxide Hazards
remain in the ON position).
cause illness or death.
For your safety, do not operate the engine in an enclosed area such
as a garage. Your engine's exhaust contains poisonous carbon
If the engine stops and will not restart, check the engine oil level
(see page 8) before troubleshooting in other areas.
monoxide gas that can collect rapidly in an enclosed area and
cause illness or death.
Exhaust contains poisonous carbon monoxide gas
CIRCUIT PROTECTOR (applicable types)
that can build up to dangerous levels in closed areas.
The circuit protector protects the
battery charging circuit. A short
Breathing carbon monoxide can cause
circuit, or a battery connected with
Exhaust contains poisonous carbon monoxide gas
reverse polarity, will trip the circuit
unconsciousness or death.
that can build up to dangerous levels in closed areas.
protector.
Never run the engine in a closed, or even partly closed
Breathing carbon monoxide can cause
The green indicator inside the circuit
area.
protector will pop out to show that the
unconsciousness or death.
circuit protector has switched off. If
this occurs, determine the cause of
Review the instructions provided with the equipment powered by
Never run the engine in a closed, or even partly closed
the problem, and correct it before
this engine for any safety precautions that should be observed with
area.
resetting the circuit protector.
engine startup, shutdown, or operation.
Push the circuit protector button to
Review the instructions provided with the equipment powered by
Do not operate the engine on slopes greater than 20° (36%).
reset.
this engine for any safety precautions that should be observed with
engine startup, shutdown, or operation.
STARTING THE ENGINE
Do not operate the engine on slopes greater than 20° (36%).
1. Move the fuel valve lever to the ON position.
STARTING THE ENGINE
1. Move the fuel valve lever to the ON position.
37Z4V6100.fm ページ ２０１８年１０月４日 木曜日 午後１時５４分
2. To start a cold engine, move the choke lever to the CLOSED
position.
3. Move the throttle lever away from the MIN. position, about 1/3
2. To start a cold engine, move the choke lever to the CLOSED
of the way toward the MAX. position.
position.
37Z4V6100.fm ページ ２０１８年１０月４日 木曜日 午後１時５４分
CLOSED
THROTTLE LEVER
CLOSED
3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
THROTTLE LEVER
To restart a warm engine, leave the choke lever in the OPEN
position.
Some engine applications use a remote-mounted choke control
To restart a warm engine, leave the choke lever in the OPEN
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted choke lever shown here. Refer
position.
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
to the instructions provided by the equipment manufacturer.
Some engine applications use a remote-mounted choke control
rather than the engine-mounted choke lever shown here. Refer
4. Turn the engine switch to the ON position.
to the instructions provided by the equipment manufacturer.
EXCEPT ELECTRIC
STARTER TYPES
Some engine applications use a remote-mounted throttle control
ENGLISH
rather than the engine-mounted throttle lever shown here. Refer
to the instructions provided by the equipment manufacturer.
ENGINE SWITCH
ENGLISH
4. Turn the engine switch to the ON position.
EXCEPT ELECTRIC
STARTER TYPES
ENGINE SWITCH
23
CIRCUIT
PROTECTOR
ON
OFF
ON
OFF
ON
OFF
CHOKE LEVER
CHOKE LEVER
CLOSED
MAX.
CLOSED
MIN.
3
MAX.
MIN.
ELECTRIC STARTER TYPES
ELECTRIC STARTER TYPES
ON
ON
ON
ON
ENGINE SWITCH
FUEL VALVE LEVER
FUEL VALVE LEVER
ON
ON
5. Operate t
RECOIL S
Pull the s
briskly in
starter gr
5. Operate th
OPEN
RECOIL S
MIN.
OPEN
Pull the st
1/3 POSITION
briskly in
starter gri
MIN.
1/3 POSITION
Do not al
Return it
ON
ELECTRIC
Turn the
and hold
starts.
Do not all
Return it g
If the eng
ON
seconds,
ELECTRIC
least 10 s
ON
starter ag
Turn the k
and hold i
starts.
Using the
than 5 sec
If the engi
the starte
seconds, r
This type
least 10 se
covered u
ON
starter ag
When the
key, allow
Using the
position.
than 5 sec
the starter
6. If the cho
This type
the engin
covered u