Table of Contents
Advertisement
1
General information
1.1
About these instructions
These installation and operating instructions are an integral part
of the product. Read these instructions before commencing work
and keep them in an accessible place at all times. Strict adherence
to these instructions is a precondition for the intended use and
correct operation of the product. All information and markings on
the product must be observed.
The language of the original operating instructions is German. All
other languages of these instructions are translations of the ori-
ginal operating instructions.
1.2
Copyright
These installation and operating instructions have been copy-
righted by the manufacturer. Contents of any kind may not be re-
produced or distributed, or used for purposes of competition and
shared with others.
1.3
Subject to change
The manufacturer reserves the right to make technical modifica-
tions to the device or individual components. The illustrations
used may differ from the original and are intended as an example
representation of the device.
1.4
Warranty
The specifications in the current "General Terms and Conditions"
apply to the warranty and the warranty period. These can be
found at www.wilo.com/legal
Any deviations must be contractually agreed and shall then be
given priority.
Claim to warranty
If the following points are complied with, the manufacturer is ob-
ligated to rectify every qualitative or constructive flaw:
ƒ
The defects are reported in writing to the manufacturer within
the warranty period.
ƒ
Application according to intended use.
ƒ
All monitoring devices are connected and tested before com-
missioning.
Exclusion from liability
Exclusion from liability excludes all liability for personal injury, ma-
terial damage or financial losses. This exclusion ensues as soon as
one of the following applies:
ƒ
Inadequate configuration due to inadequate or incorrect in-
structions by the operator or the client
ƒ
Non-compliance with installation and operating instructions
ƒ
Improper use
ƒ
Incorrect storage or transport
ƒ
Incorrect installation or dismantling
ƒ
Insufficient maintenance
Installation and operating instructions Wilo-Rexa CUT GI
General information
ƒ
Unauthorised repairs
ƒ
Inadequate construction site
ƒ
Chemical, electrical or electro-chemical influences
ƒ
Wear
2
This chapter contains basic information for the individual phases
of the life cycle. Failure to observe this information carries the fol-
lowing risks:
ƒ
Injury to persons from electrical, mechanical and bacteriolo-
gical factors as well as electromagnetic fields
ƒ
Environmental damage from discharge of hazardous sub-
stances
ƒ
Property damage
ƒ
Failure of important functions of the product
Failure to observe the information contained herein will result in
the loss of claims for damages.
The instructions and safety instructions in the other chapters
must also be observed!
2.1
These installation and operating instructions set out safety in-
structions for preventing personal injury and damage to property.
These safety instructions are shown differently:
ƒ
Safety instructions relating to personal injury start with a signal
word, are preceded by a corresponding symbol and are
shaded in grey.
ƒ
Safety instructions relating to property damage start with a
signal word and are displayed without a symbol.
Signal words
ƒ
DANGER!
Failure to observe the safety instructions will result in serious
injuries or death!
ƒ
WARNING!
Failure to follow the instructions can lead to (serious) injuries!
ƒ
CAUTION!
Failure to follow the instructions can lead to property damage
and a possible total loss.
Safety
Identification of safety instructions
DANGER
Type and source of the danger!
Consequences of the danger and instructions for
avoidance.
CAUTION
Type and source of the danger!
Consequences or information.
en
5
Advertisement
Table of Contents
Need help?
Do you have a question about the Rexa CUT GI and is the answer not in the manual?