Program Example - VERDER CARBOLITE GERO E Series Installation, Operation And Maintenance Instructions

For a more detailed view, press page
its contents as shown in the Navigation Diagram below. Provided the unit is first put into
'Hold' mode, temporary changes may be made to parameters; these apply only until
the program ends or is reset.
To pause a program, press Run/ Hold; the 'Hold' light comes on. To terminate a
program, press Run/ Hold for 2 seconds; the 'Run' and 'Hold' lights go out.
While the program is operating, the working setpoint is shown in the lower display.

3.3.6 Program example

The following sequence of entries creates and runs the program.
1. Press page
2. Press scroll
3. Press scroll
4. Press scroll
5. Press scroll
6. Press scroll
7. Press scroll
8. Press scroll
9. Press scroll
10. Press scroll
11. Press scroll
12. Press scroll
13. Press scroll
14. Press scroll
15. Press scroll
16. Press scroll
17. Press scroll
18. Press scroll
19. Press scroll
20. Press scroll
21. Press scroll
22. Press scroll
23. Press scroll
24. Press the page
25. Press the 'Run' key. The program operates.
key until 'ProG LiSt' is displayed.
until 'CYC.n' is displayed and use the arrow key to select 1.
until 'SEG.n' is displayed and use the arrow key to select 1.
until 'tYPE' is displayed and use the arrow key to select rmP.r.
until 'tGt' is displayed and use the arrow key to select 600.
until 'rAtE' is displayed and use the arrow key to select 5.0.
until 'SEG.n' is displayed and use the arrow key to select 2.
until 'tYPE' is displayed and use the arrow key to select dwEl.
until 'dur' is displayed and use the arrow key to select 60.0.
until 'SEG.n' is displayed and use the arrow key to select 3.
until 'tYPE' is displayed and use the arrow key to select rmP.t.
until 'tGt' is displayed and use the arrow key to select 400.
until 'dur' is displayed and use the arrow key to select 60.0.
until 'SEG.n' is displayed and use the arrow key to select 4.
until 'tYPE' is displayed and use the arrow key to select 'dwEll'.
until 'dur' is displayed and use the arrow key to select 30.
until 'SEG.n' is displayed and use the arrow key to select 5.
until 'tYPE' is displayed and use the arrow key to select rmP.r.
until 'tGt' is displayed and use the arrow key to select 30.
until 'rAtE' is displayed and use the arrow key to select 5.0.
until 'SEG.n' is displayed and use the arrow key to select 6.
until 'tYPE' is displayed and use the arrow key to select 'End'.
until 'End.t' is displayed and use the arrow key to select 'dwEll'.
key until you return to the main display.
to access the 'Run' list page and scroll
3.0 2416 Controller
to see
23