Advertisement
22
Combined retractable tie-down and occupant restraints
Fit and use
Fitting and using combined retractable tie-down and
occupant restraint
Floor anchor - Quattro or Quattro Express with static occupant restraint
1. The Solo anchors will have been installed in the vehicle in accordance with our own
and the vehicle converters instruction.
2. Attach the front wheelchair tie-down (not supplied as part of this product) in
accordance with its own instruction.
3. If using Quattro tie-down, it should first be fitted as indicated on page 18-19.
4. If using Quattro Express tie-down, it should first be fitted as indicated on page 20-21.
5. The occupant restraint should be installed in accordance with previous safety
information using the supplied hardware (Fig 19). Note: if fitting hardware, other than
that provided in this kit, is to be used then the fixing bolts should be of an equivalent
cross section and an equivalent grade namely B.S. Grade 'S' (ISO 8.8).
6. The componentry is assembed (Fig 19) with the upper 3
anchorage position on the vehicle body. Bolts should be tightened to a torque of
40Nm. If installing the ATF of the removable 3
known as a cant rail, should be installed in the vehicle. Note: all vehicle anchorage
points may require reinforcement as necessary to meet any required minimum
strength recommendations for the vehicle.
7. Install the static lap belt section - tongue side into the stalk opposite the 3
anchorage (Fig 20B) and the buckle side into the stalk nearest to the 3
anchorage (Fig 20A).
8. Draw the two sections around the occupant's waist and clip the lap belt adjuster into
the lap belt buckle, adjusting as firmly as possible, consistent with user comfort, so
that the lap belt sits low over the front of the pelvis and bears over the bony part of the
body.
9. Disconnect the shoulder belt snap clip from its storage position (Fig 21) and draw
across the upper body connecting it into the static lap belt section - tongue side snap
button (Fig 22). Adjust the shoulder belt tension to comfortably suit the user (Fig 23).
10. The lap belt anchor points should be positioned to achieve belt angles of 30° or more
to the horizontal and preferably between 45° and 75° in order to fit low across the
pelvis, reducing the possibility of the belt loading the abdomen (Fig 7). The pelvic
restraint is designed to bear upon the bony structure of the body and should be worn
low across the front of the pelvis with any junctions between the pelvic and shoulder
restraints located near the wearer's hips.
point bolted to an approved
rd
point, then a suitable rail section,
rd
rd
point
rd
Removing occupant restraint
1.
Disconnect the shoulder belt snap
clip from the lap belt snap button
and the lap belt tongue section
from the lap belt buckle section.
2.
To remove the wheelchair
tie-down, see page 18 or 20.
Occupant restraints should not
be held away from the body by
wheelchair components or parts, such
as armrests or wheels, and should not
point
be worn twisted in any way.
Occupant restraints should be
adjusted as firmly as possible and
consistent with user comfort. Upper
torso restraints should fit over the
shoulder or shoulders.
Advertisement
