Faq - Floe Versa-Max UT Owner's Manual

WHAT CAN CAUSE VIBRATION IN MY TOW
VEHICLE?
1. Over-tight hitch coupler -- See procedure for adjusting hitch
coupler earlier in this book.
2. Loose or worn wheel bearings -- See procedure for replacing
wheel hub earlier in this book.
3. Loose wheels -- See procedure for changing tires earlier in
this book.
4. New tires -- It is possible that the new tires are out of round.
Once they are inflated to the proper PSI and used for a
short period of time on a loaded trailer, they should work
themselves round. New tires that are still out of round after
an ample break in period may be defective and need to be
replaced. Call the tire manufacturer or your local FLOE
dealer for replacement.
5. Unbalanced wheel hubs -- If your tires are balanced and not
out of round this may be the problem. Replace if necessary.
WHY DOES MY TRAILER SWAY OR WHIP?
1. Trailer is not being towed level -- Refer to hitch selection
and use section of this manual.
2. Not enough tongue weight -- Refer to loading and unloading
section of this manual.
3. Overloaded trailer -- Refer to loading and unloading section
of this manual.
4. Too much tongue weight -- Refer to loading and unloading
section of this manual.
WHY ARE MY TIRES WEARING UNEVENLY?
1. Unequal side-to-side loading -- Refer to Proper Loading
and Unloading section of this manual.
2. Tires not inflated to proper PSI
3. Wheel bearings are not properly tightened & oiled.
CAN I REPLACE MY TIRES WITH LARGER ONES?
The Versa-Max UT trailers are designed for use with
TM
ST205/75 R14-C tires with mag rims and may not be
substituted for a larger size.
Questions & Answers
WHERE DO I FIND MY VIN TAG?
1. The VIN tag is located under the bed of the Versa-Max UT
– on the tongue mount – on the driver's side of the trailer.
Tag is on tongue mount under trailer
WHY DO I KEEP BLOWING FUSES WHEN I
CONNECT OR USE MY TRAILER LIGHTS?
1. A wire is cut or bare and is shorting out -- Visually locate
and repair or replace.
2. Wrong size fuse in tow vehicle -- The trailer lighting system
draws 1/2 amp not taking into account anything else on this
circuit.
WHY DO MY LIGHTS BLINK ON AND OFF?
1. Corrosion on wire connections -- Check all connections for
corrosion, clean and apply electrical grease to prevent future
corrosion.
2. Improper or loose ground to tow vehicle -- This may cause
all lights to blink or cause your marker lights to blink when
you turn on your turn signals.
For additional information, please contact your Authorized
FLOE Dealer, visit our website at www.floeintl.com or call:
1-800-336-6337 to locate the dealer nearest you.
Trouble Shooting
- - - - - - - - - - - - - - IMPORTANT- - - - - - - - - - - - - -
13