Page 1
Owner’s manual CARGO CARGO XRT 8-57 XRT 8-57 Xtreme Rugged Technology Xtreme Rugged Technology The ulTimaTe “grab and gO” Trailer! all trailer users should watch the 4 minute basic Operations video prior to using trailer. Go to www.floeintl.com/manuals-information and click on “Play Video”. retain this manual for future reference.
“leading edge” and providing the best available trailer. We are confident your FLOE trailer will provide you with years of trouble-free trailering, and that if you decide to buy another trailer, it is because you want another FLOE model.
However, NHTSA cannot become involved in individual • Check that lug nuts on each wheel are tight problems between you, your dealer, or FLOE International, Inc. • Check that wheel bearings are properly tightened and greased To contact NHTSA, you may either call the Auto Safety Hotline toll-free at 1-888-327-4236 (TTY: 1-800-424-9153);...
Hitch Coupler Adjustment All FLOE models have a lever lock hitch coupler. With a lever lock coupler, the amount of locking force can be adjusted to the diameter of the hitch-ball. A coupler that is adjusted too tight will make it difficult to push down on the lever lock and may cause vibration from the trailer to the tow vehicle.
Using your FLOE trailer Tilt Clamp The FLOE tilt clamp eliminates the hassle and rattle of a warning hitch pin design. To tilt, simply loosen the handle screw, remove the safety cotter pin, and slide clamp forward. When finished loading or unloading, slide clamp...
Using your FLOE trailer Trailer Lighting System wire HarneSS ConneCtor warning • Your trailer is equipped with a plug-in receptacle on the trailer tongue (FIG. 1) to keep the electrical connector Make sure the wiring harness for the lighting system is protected when not in use, as shown.
Using your FLOE trailer Secure your Trailer ConneCting SafetY CHainS SECURinG TOnGUE jACk Safety chains must be hooked up every time the trailer is in Tongue jack must be properly secured in the travel position use. To connect safety chains properly be sure they cross each before moving the trailer (see image below).
Loading your FLOE trailer Proper Loading & Unloading 1. Prior to using the trailer loaded or unloaded it is imperative warning that no structural damage exists. Do a visual check to ensure that none of the structural components are bent or cracked.
(FIG. 4). 1800 lbs Cargo Max XRT 8-57 2. Cargo must be secured so that tie down restraints can not Exceeding these load capacities could cause product failure become loose while traveling.
Page 10
procedure for Aluminum Tailgate Ramp When using the tailgate ramp, the trailer can either be left in regular (upright) position, or partially tilted using the limiter strap. This creates the perfect angle for low clearance items. To lower tailgate ramp, Tailgate ramp removes in simply squeeze the spring- seconds with no tools.
procedure for Changing tires warning CHanging tireS 1. Start all lug nuts by hand to prevent cross-threading and to Improper tire pressure can create ensure proper nut-to-rim seal. severe dangers. Be sure your tires are 2. Tighten bolts in the sequence detailed below in stages, first always properly inflated.
procedure for inspections & maintenance It is very important to read and follow these maintenance procedures to help avoid trailer failure. Any trailer failure resulting from improper maintenance may void your warranty. Component inSPECTiOnS & mAinTEnAnCE avoiD Structure/Frame a) Do a visual check to ensure that none of the structural a) Loading the trailer in an unbalanced components are bent or cracked before towing.
procedure for maintaining Hub Lubrication wHeel Hub lubriCation - - - - - - - - - - - - - - IMPORTANT - - - - - - - - - - - - - - Your hub/spindle is equipped with a lubrication system. The A complete inspection and greasing of wheel hubs is required bearings can be periodically lubricated without removing the hubs from the axle.
SUPER LUBE LIMITED WARRANTY Limited Warranty TIE DOWN ENGINEERING Inc. ("TIE DOWN") warrants its products to be free from defects in material and workmanship for one year from date of delivery when properly maintained by the purchaser. One year for parts and labor. This warranty does not apply to damage or loss caused by any or all of the following circumstances or conditions: •...
2. Improper or loose ground to tow vehicle -- This may cause be replaced. Call the tire manufacturer or your local FLOE all lights to blink or cause your marker lights to blink when dealer for replacement.
This warranty covers only the cost of replacement of materials due to defects in materials or workmanship and represents the only warranty authorized by us. In order to receive performance under this warranty, all warranty repairs must be authorized in advance by FLOE International. FLOE International will not be responsible for any costs incurred for unauthorized repairs! Unauthorized repairs may void the warranty on items repaired! This warranty does not cover any damages due to overloading of trailer, damage resulting from road hazards, damage caused by wear rods or traction products, jackknifing, misuse, or negligence.
Need help?
Do you have a question about the CARGO MAX XRT 8-57 and is the answer not in the manual?
Questions and answers