Chapter 3: Using the KVM-04P
The KVM-04P switch unit provides two ways to select which computer is the active system. Use
either the "Select" button on the unit, or make use of the keyboard "Hot key" commands.
You may notice that the mouse cannot be used for around 2 seconds when the KVM-04P switch-
es to another computer. This is normal and is caused by synchronization.
"SELECT" Button
Pressing the Select button cycles through computers 1 ~ 4
Console
PS/2 Keyboard
Keyboard "HOT KEY" commands
To send "Hot Key" commands to the KVM-04P unit, press the SCROLL LOCK Key twice within 2
seconds.
You will be given a beep as confirmation. Now press a command key to give a "Hot Key" com-
mand. The following commands are supported:
This Combination
Scroll Lock
Scroll Lock
Scroll Lock
Scroll Lock
Scroll Lock
Scroll Lock
Scroll Lock
Port Status
1
2
3
4
4-Port KVM Switch
Console
PS/2 Mouse
Scroll Lock
1
Scroll Lock
2
Scroll Lock
3
Scroll Lock
4
Scroll Lock
Scroll Lock
Scroll Lock
S
Port Select
Select
=
Switch to First PC
=
Switch to Second PC
=
Switch to Third PC
=
Switch to Fourth PC
=
Switch to Previous PC
=
Switch to Next PC
=
Go to Auto Scan Mode
6
Does This