Installation and Maintenance
5.5 Fitting Remote Controller XS-MFC or
Remote sensors (optional)
The XS-MFC Multi Fan Control provides supply or extract, variable
speed and automatic or manual switching of several fans if desired, (see
note below). The control is best mounted approx 1.5m above the floor.
Remote Sensors are available for Humidity, Air Quality and Passive Infra
Red control. Remote Sensors should be positioned at least 1.5m above
the floor and away from direct heat sources e.g. radiators.
Note:
Up to 5 fans (size 6 / 9 inch) can be controlled by one XS-MFC.
Up to 2 fans (size 12 inch) can be controlled by one XS-MFC.
Do not mix different fan sizes on the same controller.
2
Push out backplate box cable entry using a screwdriver.
4
Fix backplate box to the prepared ceiling.
6
Connect the end of the cable into the control block.
nuaire.co.uk
029 2085 8400
XS Ceiling Fan Kits 50/60Hz
1
Lift up panel and remove two screws to dismantle unit.
3
1.5m
Spot through backplate box and drill and plug the ceiling.
5
Feed approx. 200mm of supply cable into the box
7
Fit the control into the backplate box and secure.
Test the installation.
15. 09. 17. Leaflet Number 671052
200mm
7