US Shift Quick 2 GEN2 Installation And Operation Manual page 34

OSS Circuit Open or Sensor Missing
The Output Shaft Speed Sensor circuit is open or the sensor is missing.
ISS Circuit Open or Sensor Missing
The Input Shaft (Turbine) Speed Sensor circuit is open or the sensor is missing.
(if equipped)
OSS Sensor Signal Plausibility Error
The controller detected an unexpected value from this sensor and marked it as
faulty.
ISS Sensor Signal Plausibility Error
The controller detected an unexpected value from this sensor and marked it as
faulty. (if equipped)
Checksum error in table
A Checksum error has been found in the calibration table. It will also disable
saving Setup Menu changes and disable the tuning menu. Connect the
controller to a PC and load a calibration using Shiftware.
Torque Converter Clutch Slip Error
Torque converter clutch slip detected when fully engaged.
Transmission Slip in Gear(s) 1, 2, 3, etc.
Transmission appears to be slipping in the indicated gear or gears.
Transmission Slip with Max Pressure
Transmission continued to slip after maximum line pressure was commanded.
Transmission Slip Repeated > 2x
Transmission slip was detected more than twice in this drive cycle (max. line
pressure latched).
Ratio too High in Gear(s) 2, 3, 4, etc.
Transmission gear ratio appears to be too high in the indicated gear or gears.
Error: PRNDL Out of Range
Sensor voltage is out of tolerance limits, but within approximate range.
34