Table of Contents
Advertisement
5.3. Drainage and storage
Drainage
1
Check the stopper on the bottom of the pool and the drain cap.
2
Remove the stopper on the bottom of the pool. Completely drain all water from the
3
spa pool.
Once empty, the pool can be cleaned with soap and water.
4
1
2
Storage
5
6
7
8
It is recommended that you store the SPA in its original package in a warm dry place.
5
6
5.4. Repair kit
Small punctures or holes in the pool liner can be repaired with the repair kit included.
2. Thoroughly clean the area surrounding the leak.
3. Cut a piece of repair material in round shape, which should be larger than the dam-
aged area.
4. Apply adhesive to the underneath side of the patch and around the area to be re-
paired.
to dry. After patch has dried, apply glue around the edges for a complete seal (dry 4
hours).
12
3
dry for 24 hours
7
8
6 . T R O U B L E S H O O T I N G
If air valve damages or leaks, please replace valve according to the steps followed.
Directly press down spring
spindle.
6.1. Troubleshooting
Here are some useful tips to help you to diagnose and rectify common sources of
trouble.
Problem
Cause
Control panel
screen does not
Check power source
operate
Temperature set is too low
SPA pump does not
heat properly
Too low water level
Heating element defective
Pump is overheating
Bubble massage
system does not
activated
work
Malfunction of the pump unit
Inlet and outlet blocked
not work
Air inside the pump
Malfunction of the pump unit
Adaptor seal improperly
Pump leakage
Water leakage from pump body
Spa pool leakage
Spa pool is torn or punctured
Water is not clean
Improper water treatment
Replace a new air valve spindle.
Tighten the air valve by tools.
Solution
Power failure
Call for service if it does not reset
Set to a higher temperature
Clean or Replace the cartridge (see chapter 5.2)
Call for service
Cut off the power and wait until the pump has cooled.
Press the bubble button to reactivate
Call for service if it does not reset
Clean or Replace the cartridge (see chapter 5.2)
Clean the inlet and outlet
Call for service if it does not reset
Replace the seal in the right position
Check the pump body, call for service
Clean or Replace the cartridge (see chapter 5.2)
Change the pool water completely
Refer to the chemical manufacturer's instructions
EN
13
Advertisement
Table of Contents
