Setup; Installing The Handle - Toro Recycler Operator's Manual

Setup

Important:
Remove and discard the protective plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1. Remove the handle knobs and corresponding bolts from the lower handles (A of
2. Position the upper handle on the lower handles and then unfold the handle (B of
3. Ensure that the cables are routed to the outside of the handle (C of
4. Install the handle knobs with the corresponding bolts and tighten them firmly by hand (D of
Figure 3
4
Figure 3).
Figure 3).
Figure 3).
Figure 3).
g305902