Servicing The Air Filter; Changing The Engine Oil - Toro Recycler Operator's Manual

Servicing the Air Filter

Service Interval: Before each use or daily
Yearly
1. Press down on the latch tabs on top of the
air-filter cover (Figure
Figure 17
1. Latch tabs
2. Open the cover.
3. Remove the air filter
Figure 18
4. If the air filter is damaged or is wet with oil or
fuel, replace it.
5. If the air filter is dirty, tap it on a hard surface
several times or blow compressed air less than
207 kPa (30 psi) through the side of the filter
that faces the engine.
Note:
Do not brush the dirt off the filter;
brushing forces dirt into the fibers.
6. Remove dirt from the air-filter body and cover
using a moist rag. Do not wipe dirt into the
air duct.
7. Install the air filter.
8. Close the cover.

Changing the Engine Oil

Service Interval: Yearly
17).
(Figure 18).
Note:
Run the engine a few minutes before changing
the oil to warm it. Warm oil flows better and carries
more contaminants.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Refer to Preparing for Maintenance (page
3. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
g002902
g002903
4. Tip the machine onto its side (so that the air
filter is up) to drain the used oil from the oil-fill
tube (Figure
17
0.55 L (18.6 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
Figure 19
19).
Figure 20
16).
19).
g186326
g020050