Cleaning And Maintenance; Cleaning The Machine And Filters; Spray Arms - Sharp QW-GD54R443X-EU User Manual

Table of Contents

Advertisement

8. CLEANING AND
MAINTENANCE
Cleaning your Dishwasher is important
to maintain the machine's service life.
Oil and lime may build up in your
Dishwasher over time. If this occurs:
Fill the detergent compartment
but do not load any dishes. Select
a programme which runs at high
temperature and run the Dishwasher
empty. If this does not clean your
Dishwasher sufficiently, use a
cleaning agent designed for use with
dishwashers.
Wipe the door seals regularly
with a damp cloth to remove any
accumulated residue.
8.1. Cleaning machine and filters
Clean the filters and spray arms at least
once a week. If any food waste remains on
the coarse and fine filters, remove them and
clean them thoroughly with water.
a) Micro Filter
b) Coarse Filter
c) Metal Filter
1
c
3
To remove and clean the filter combination,
turn it counter clockwise and remove it by
lifting it upwards (1).Pull the coarse filter out
of the micro filter (2).Then pull and remove
the metal filter (3).Rinse the filter with lots of
water until it is free of residue. Reassemble
b
a
2
4
EN - 21
the filters. Replace the filter insert, and
rotate it clockwise (4).
Never use your Dishwasher without a
filter.
Incorrect fitting of the filter will reduce
the washing effectiveness.
Clean filters are necessary for proper
running of the machine.

8.2. Spray arms

Make sure that the spray holes are not
clogged and that no food waste is stuck
to the spray arms. If there is any clogging,
remove the spray arms and clean them
under water. To remove the upper spray
arm undo the nut holding it in position
by turning it clockwise and pulling it
downwards. Make sure that the nut is
properly tightened when refitting the upper
spray arm.

Advertisement

Table of Contents
loading

Table of Contents