Unpacking And Checking Carton Contents; Assembly - Vacmaster VQ1530SFDC Manual

UNPACKING AND CHECKING CARTON
1 Carry Handle
2 On/Off Switch
3 Power Take-off Socket 12 Power Cord Storage Hooks
4 Suction Port
5 Container
6 Drainage Port
7 Power Head
8 Accessory Storage
9 Latch
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Attach the carry handle into the slots located on the top of the power head (Fig. 1).
3) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed.
If the cartridge filter is not installed, refer to page 8.
5) Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 3).
6) For wet vacuuming, replace the cartridge filter with the foam filter supplied. Do not use a dust
bag when wet vacuuming. If the foam filter is not installed, refer to page 9.
7) Secure the power head back on the container, using the 2 side latches. Insert the locking end
of the hose into the suction port of the container (Fig. 4).
8) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
CONTENTS
10 Caster
11 Blowing Port
13 Anti-static Chain
14 Hose
15 Extension Wand (x2)
16 Crevice Tool
17 Handle with Air Flow Regulation 26 Instruction Manual
18 Floor Nozzle

ASSEMBLY

7
19 Power Tool Hose Adaptor
20 Round Dust Brush
21 Cartridge Filter (pre-installed)
22 Filter Retainer (pre-installed)
23 Dust Bag
24 Foam Filter
25 Screw (x6)
GB