Dakota Digital Odyssey II Series Manual

Wiring:
GND -
PWR -
DIM -
SND -
Mounting:
The gauge requires a round hole 2-1/16" diameter for mounting. The gauge should be inserted into the
opening from the front and the U-clamp will be installed from the back. Tighten the two nuts on the U-clamp so that
the gauge is secure. Gauge depth to the back of the case is 1". Gauge depth including the mounting studs is 1-
7/8".
Factory settings:
240 – 33 ohms GO THROUGH SETUP TO CHANGE THIS TO MATCH YOUR SENDER.
Sender type:
Full tank reading:

User adjustable for GM, Ford, VDO, or Stewart Warner senders.

User selectable to display %full or gallons remaining.

The gauge will flash any time the fuel level is below 10% to warn of low fuel.
Fuel sender resistances:
Sender type
GM 30
GM 90
GM 250
Ford 10
Ford 150
VDO 180
Stewart Warner/Sun 33 240 ohms
Import 4
If a sender is not connected properly or the gauge is not set for the sender, the display will show "EEE". If the SND
terminal is shorted to ground, the display will show "---". When the gauge is set for a GM sender the gauge will flash
"00" when shorted to ground, not show the "--" since 0 ohms is a valid reading for the GM sender.
ODYR/SLX-06 FUEL LEVEL rev. B
connect to a main ground location
connect to fused switched 12 volt power. (An accessory terminal will work for this.)
Night Dimming: connect to the head light switch.
connect to the fuel level sender. SET THE SENDER TYPE FIRST
100%.
empty resistance
0 ohms
0 ohms
40 ohms
73 ohms
20 ohms
10 ohms
112 ohms
Series II
full resistance .
30 ohms
90 ohms
250 ohms
10 ohms
150 ohms
180 ohms
33 ohms
4 ohms
MAN# 650007