Installing 2.5" Internal Hard Disk Drive - Fostex FD-4 Service Manual

FD-4

6. INSTALLING 2.5" INTERNAL HARD DISK DRIVE

The Model 9045 and a 2.5" E-IDE hard disk drive installing procedures are explained below.
Model 9045 Contents
• Bracket, HD, FD-4 (P/N: 8221234000) x 2
• Connector, PI, header, 50P, AMPMOD (P/N: 8245314000) x 1
• Cable, flat, 2P, L150 (P/N: 8276292015) x 1
• Cable assy, flat, 50P, P1.0, AMPMOD, L150 (P/N: 8277465015) x 1
• 14 x screws (P 3 x 4 CZn)
Installing Procedures
1) Loosen 14 x screws (BBT 3 x 8 BZn) which fix the FD-4 Top Panel section to the Bottom Panel section.
2) Remove the following cables from the connectors on the MAIN PCB assy.
• 9-pin cable to the J3 (coming from MIXER A PCB assy)
• 9-pin cable to the J7 (coming from DISPLAY PCB assy)
• 7-pin cable to the J10 (coming from MIXER A PCB assy)
Top Panel section
Bottom Panel section
BBT 3x8 BZn
20
MAIN PCB assy
BBT 3x8 BZn