Fostex FD-4 Service Manual page 14

FD-4
Key/Button/Jog Dial
RECORD
STOP
PLAY
REWIND/
F FWD/
SHIFT
VARI PITCH/ P.EDIT
AUTO RTN/PLAY
LOCATE/ LOC MEM
HOLD/
STORE
4-5. Self Check
14
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
No. Key/Button/Jog Dial
K01 EDIT
K02 UNDO/REDO
K03 EXECUTE/YES
K04 EXIT/NO/ EJECT
K05 AUTO RTN START
K06 AUTO PUNCH IN
K07 AUTO PUNCH OUT
K08 AUTO RTN END
K09 CLIPBOARD IN
K10 CLIPBOARD OUT
K11 DISP SEL
: Blinking
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
In this condition, if the EXECUTE/YES key is pressed one
more time, the Button Test can be executed.
The Button Test checks if each key/button and jog dial are
working properly or not. The display on the left indicates
that the RECORD button is pressed. ("K" stands for the Key
and "J" the Jog dial.)
The display on the left indicates that the jog dial is turned
C.W.
The table below shows the relationship between the key/
button/jog dial and the corresponding numbers appear on
the LCD display.
In order to quit the Button Test, turn the jog dial C.W. or
C.C.W. further after "J 020" or "J-19" is displayed
respectively.
No. Key/Button/Jog Dial
K12 SETUP
K13 TIME BASE SEL
K14 RECORD TRACK 1/L
K15 RECORD TRACK 2/R
K16 RECORD TRACK 3/L
K17 RECORD TRACK 4/R
K18 RECORD TRACK 5/L
K19 RECORD TRACK 6/R
K20 JOG DIAL (C.W.)
K21 JOG DIAL (C.C.W.)
K22
This mode automatically tests the following points in order.
• SCSI bus
• ATA bus
• MIDI in/out circuit
• S/P DIF digital signal (44.1kHz)
• 32kHz digital signal
• Vari-pitch circuit
• A/D and D/A circuit (Input Monitor)
No.
K23
K24
K25
K25
K25
K25
K25
K25
J 00 ~ 20
J -00 ~ -19