Num'axes Canicom 200 First Technical Support page 3

− When pressing the
− Before disconnecting the test lamp, make sure the collar is switched off (indicator light off).
Renew the radio coding between collar and remote control.
Radio coding enables the transmitter (remote control) to work with the receiver (collar).
To code the remote control with the collar once again, proceed as follows:
− The remote control must be ready for use (battery in place).
− The receiver collar must be switched off (indicator light off).
− Move the remote control towards the collar so that the red mark on the remote control comes
into contact with the red mark on the collar, hold for 6 seconds (see diagram below). The
indicator light on the collar lights in fixed green then flashes in red.
− Move the remote control away from the collar.
− Press the
button of the remote control. A beep sound is emitted; the collar is synchronized
with the remote control.
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new one
from the Canicom range.
Place these two areas
together for 6 seconds
Re-initialize the collar (reset).
To re-initialize the system proceed as follows:
− Unscrew the 4 screws of the battery cover and
remove the battery from its housing.
− With a metallic tool (e.g. scissors), connect the 2
battery supports for approximately 2 seconds.
− Insert the battery once again (one beep sound
must be emitted indicating the correct installation
of the battery).
− Test the product with the neon test lamp (see
paragraph "Check
correctly").
Canicom 200 First technical support
button, the collar must emit a beep sound.
the product operates
www.numaxes.com
Reset: connect the 2
battery supports
maj 08/2020 - 3/5